How to install a humbucker in an SSS Stratocaster

How to install a humbucker in an SSS Stratocaster

It’s a divisive question: on one side, the aficionados/hipsters who think a Strat must have a single-coil at the bridge to keep the essence of the original sound, its inimitable charm and also, let’s admit it, its limitations; on the other, those who think it’s actually rather nice to add a (relatively) modern touch to this iconic instrument.

I still had a DiMarzio Tone Zone lying around, as well as my beloved Mexican Standard SSS Strat, which was also lying around, though a bit less. So I told myself I shouldn’t miss out on something cool; you only live once, after all.

It’s not a mod idea that came out of nowhere: I’d learned to appreciate the Tone Zone and DiMarzio pickups in general through a friend. He’d introduced me to the Ibanez Custom USA guitars from the golden era, and I’d always kept fond memories of them.

All this to say that the idea of installing a Tone Zone in my SSS Strat eventually took root.

On the body side, there’s no problem fitting the pickup, and a bit of Dremel work lets you adapt the pickguard. On the electronics side, however, the problem is that humbuckers are known to sound their best with a 500k pot. But here’s the catch: the stock pot on Stratocasters is 250k.

How to do it in practice

The idea is to replace the stock 250k pot with a 500k and add a 500k resistor in parallel on the middle and neck pickups. This gives you the recommended 250k on the single-coils and 500k ohms on the humbucker.

Wiring diagram

Wiring diagram for a humbucker in an SSS Stratocaster with 250k and 500k pots
Humbucker in a Stratocaster

To hear what the Strat/single-coil/DiMarzio mix sounds like, check out Papastache‘s channel, because he had the same setup until a few months ago.

Be the first to comment

Leave a Reply